How to set IP addr of internal ftp server

[rjuly]

How can the IP address of the internal FTP server be set manually?

- Richard

[blaubär]

Never used it - seems not to be configurable

20220825_141832.jpg (17.02 KiB) Viewed 1177 times

[blaubär]

You probably use the ip- address of the device ... does anybody know ?

[Sylver61]

Hi,
1 connect to a lan
2 tap on the "green gear" on the right side as in the picture above
3 choose which is the folder/source you want to share
4 tap on the check bottom right
5 the ip address:port - username - password will change with the neutron internal one you have to use to connect to.
Bye

[blaubär]

[...]
5 the ip address:port - username - password will change with the neutron internal one you have to use to connect to.

Thank you, works !

20220827_172821.jpg (18.68 KiB) Viewed 1141 times

So one cannot manually set the IP-Adress, and Neutron show the one to use.

[rjuly]

I am connecting to my iphone with a dedicated ethernet connection between my iphone and my laptop. I have set the network to one that contains the ip address generated by Neutron, but I can't reach that address, either pinging from the iPhone or from the laptop, although I can reach each of the other's ethernet IP addresses. I'm not clear on what basis the Neutron assign's the FTP address. It seems to be associated with utn3, but not reachable.
- Richard

[blaubär]

I'm not clear on what basis the Neutron assign's the FTP address.

On my Samsung S9, which is connected to a WLAN, Neutron doesn't "assign" an IP-address, but takes the one used by the S9 :

20220830_135259.jpg (32.52 KiB) Viewed 1096 times

20220830_135310.jpg (18.61 KiB) Viewed 1096 times

And uses a certain port, in this case 5200 - maybe it "assigns" that.